Mgrack: Honest Boundaries for Upright Panel Handling
Mgrack is a strong fit for upright glass, stone, PV, and door/window panel flow when the route is clear. It is not the right answer for single panels above 6 m, especially 9 m-class giant sheets that need non-standard overhead tooling, for finish-critical jobs that refuse wood-crate cost, or for buyers who do not want end-user bolted assembly.
Send board size and finish requirements
A sales page that starts with the no-go list
If the job is a standard double-sided A-frame handling flow, Mgrack solves upright storage, in-plant transfer, and empty-return logistics well. If the job is a permanent wall position, a zero-assembly receiving flow, or an ultra-long panel that needs project-specific rigging, the honest answer is to stop and re-check the route before you buy. That is how we turn claim limits into trust instead of later disputes.
The short decision table
Use this checklist to decide whether Mgrack fits, what packing makes sense, and where the boundary sits.
| Decision check | What this page says clearly |
|---|---|
| Best fit | Upright handling of glass, stone, PV modules, and door/window panels in factory flow and return logistics. |
| Not a fit | Single panels above 6 m, especially 9 m-class giant sheets that need non-standard heavy-duty tooling. |
| Also not a fit | Permanent wall storage where mobility and knock-down shipping do not add value. |
| Assembly | The rack arrives as bolted components and needs on-site manual assembly. |
| Appearance risk | Free stretch-wrap packing can allow minor paint rub on long transport; wood crate protects better, costs more, and reduces loading quantity. |
| Quote inputs | Send panel material, max dimensions, unit weight, handling method, aisle limits, and surface-protection requirements. |

What to send before we recommend a route
Please confirm board size, weight, handling route, floor condition, aisle width, and whether the finish must survive long transport without visible touch-up. If the answer is yes to ultra-long panels, appearance-critical export, or no assembly at receiving, we will tell you that this standard rack is not the right fit.
- We do not promise compatibility with ultra-long, project-specific rigging jobs.
- We do not hide the trade-off between stretch-wrap packing and wood-crate protection.
- We do not treat bolted assembly as a non-issue.
When Mgrack works, and when it should be ruled out
The point is not to scare you away. It is to make the purchase safer for both sides.
Where it fits well
Choose Mgrack when you need upright, reusable handling for glass, stone, PV, or door/window panels, and when the flow includes forklift moves, caster moves, or return stacking. The rack is built for a real factory route, not a fixed wall.

Where to stop and rethink
Stop when a single sheet goes beyond 6 m, especially the 9 m-class cases that need non-standard rigging; when the buyer wants showroom-level finish but refuses wood-crate cost; or when the site will not accept end-user bolted assembly. The rubber pads and tie-down points protect the load, but they do not cancel transport physics or packaging choices.

Pre-quote checklist
Send the panel material, maximum length and width, unit weight, quantity per rack, handling method, aisle width, floor condition, and whether wood crate packing is allowed. If finish sensitivity or no-assembly is a hard requirement, say that first.
Send the panel size, the finish standard, and the handling route
If the job is standard, we will help you confirm the configuration. If it is not, we will say so before the order turns into a dispute.