EN 
DE 
RU 
FR 
PT 
ES 
IT 
JA 
GLASS HARP RACK | OPERATOR SAFETY
Worried that frequent pushing will send a glass edge into steel? Hrack combines a top nylon sealing strip with an EPDM backrest buffer so glass meets a defined protective surface—not a hard metal member—during loading, unloading, and controlled movement.
For a busy glass workshop, a small edge impact can become a chipped corner, a micro-crack, or a rejected coated panel. The risk is highest when operators push a loaded rack, pull one sheet from a slot, or return a sheet after inspection. The practical question is simple: will the glass hit steel? With the Hrack protection layout, the intended contact points are separated from the steel frame by soft, replaceable protection components.
The top nylon sealing strip closes the hard-metal exposure at the upper rack contact area. At the rear, the EPDM rubber backrest strip creates a cushioned surface where the glass leans against the sloping frame. These parts are protection components, not load-bearing members. They reduce hard contact and surface damage; they do not replace correct loading, slot selection, or operator control.
Where glass meets the rack: define the contact path
Glass should enter a numbered slot, settle into the nylon roller groove, and lean toward the protected rear support. The top nylon strip helps close the upper edge of the steel structure, while the EPDM strip cushions the rear lean point. The four-quadrant component view shows how the PVC-sleeved wire dividers, nylon roller system, EPDM backrest, and mobile base work as one handling arrangement. The PVC sleeve separates adjacent sheets; it is not the same part as the EPDM backrest and should not be described as a load-bearing support.
How the nylon and EPDM protection work during handling
During placement, the nylon components provide a non-metal interface around the top contact zone and the bottom slot uses nylon rollers to guide the sheet into position. At the rear, EPDM has the resilience needed for a cushioned lean against the backrest. This combination addresses two different risks: edge or upper-frame contact is managed by the nylon sealing detail, while rearward impact and repeated leaning are managed by the EPDM buffer. If the process involves very thin, coated, unusually shaped, or short glass, confirm the slot width, support layout, and protection material with GSR before ordering. Hrack is a configurable solution, not a universal guarantee for every glass size or handling method.
Movement safety still depends on the floor lock
Protective padding cannot stop a rack from rolling unexpectedly. The operator must first control the load, keep hands and travel paths clear, and use the foot-operated mechanical floor lock when the rack reaches its workstation. The lift-locking mechanism stabilizes the unit by raising the locking support so the casters no longer carry the moving load in the same way. Release the lock only when the rack is ready to move. The nylon top strip and EPDM backrest reduce hard contact; the floor lock controls unwanted movement. Each solves a different part of the risk.
Operator check before pushing or removing a sheet
- Check the intended slot and confirm the glass is seated in the nylon roller groove; use the numbered slot index where provided instead of forcing a sheet into a tight opening.
- Look along the top and rear contact path: the nylon sealing strip and EPDM backrest should be present, secure, and free from damage. They are protective parts, not structural load supports.
- Before moving, keep the glass stable, use the rack handle, verify the route is clear, and release the foot lock only for controlled travel. At the workstation, engage the lock before sorting or taking glass out.
- For recurring edge chipping, provide GSR with glass thickness, panel dimensions, slot spacing, travel frequency, and impact location. GSR can then assess whether an EPDM protection configuration or another slot/support arrangement is appropriate.